On my Debian Laptop it works just fine
#1Gbit cable showed up as 10 Mb/s, after tinkering it shows 100 Mb/s
ember veldt
keen wasp
On my Debian Laptop it works just fine
Is the nic on the computer a 10/100? You can check using the System Report applet in the menu. It's listed in the information tab, I think.
keen wasp
Aternatively: inxi -Nnxxx will get you The NIC info. Then put what follows 'IF:' after ethtool. It should look like ethtool enp34s0 or ethtool eth0 That will show you what the NIC is capable of.
Settings for enp34s0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Supported pause frame use: Symmetric Receive-only
Supports auto-negotiation: Yes
Supported FEC modes: Not reported
Advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Advertised FEC modes: Not reported
Link partner advertised link modes: 10baseT/Half 10baseT/Full
100baseT/Half 100baseT/Full
1000baseT/Half 1000baseT/Full
Link partner advertised pause frame use: Symmetric Receive-only
Link partner advertised auto-negotiation: Yes
Link partner advertised FEC modes: Not reported
Speed: 1000Mb/s
Duplex: Full
Auto-negotiation: on
master-slave cfg: preferred slave
master-slave status: slave
Port: Twisted Pair
PHYAD: 0
Transceiver: external
MDI-X: Unknown
netlink error: Operation not permitted
Link detected: yes