wise crow
I just got the Mode Envoy and it's a beauty. Mirage with mirror weight and accent.
I'm struggling to get rid of this super hollow sound on the top left corner. Do you guys tighten the screws all the way or what's the strategy here?
I'm currently using MX black HG with 62.5 triple long springs and abs keycaps. Also using the black gaskets.
tired breach
It's generally advised not to tighten the screw all the way. I can't speak for others, but I've added foam to help give it a bit of a fuller sound signature too.
edgy wren
I barely tighten the screws on it. I’ve noticed it helped with my unit (mirage and PC both). I did end up opting to use plate foam in my current config
severe lintel
I tightened my screws about half way, I opted for a plate foam (no case foam) for mine as my pom plate was giving me some reverberation that I could feel in my fingers as I was typing
eager olive
i dont know if this is something you are interested in doing as well but i just dont use the screws and i dont have any hollowness now. this is with zero foams and alu plate for me
wise crow
i dont know if this is something you are interested in doing as well but i just ...
I'll give that a try as well. Did you not screw the plate to the PCB as well?
eager olive
I'll give that a try as well. Did you not screw the plate to the PCB as well?
i used those when i was first putting the switches in just so i had some help with alignment but then i got rid of them after the switches were in. i think there are a lot of people that dont use those screws period.
wise crow
Nice. I took out the screws and it does sound much better! Thanks for the tip. I kept one screw on the right shift just to hold it down.