full minnow
I set up the simvar and the display according to MBF documentation but the LED only lights up for about a second when I press the AP button. In this case I am testing the heading hold button. Can someone tell me what I am doing wrong??? Here are some screenshots of my setup.
shell fable
Does Mobiflight Raw Value and Final Value columns in the main window show the value being received ok (0 and 1)?
full minnow
Yes both 0 and 1 results on the SimVar and Display tabs. Note that I am using msfs2024 with the PMDG737-900. I have licensed fsuipc handling most all of the buttons and switches and MSFS handling all axis. I only need MBF for the Honeycomb AP Light panel (7 lamps).
Also I am on version 10.5.3 MBF.
shell fable
Does the test function inside an output config turn on the leds?
I am not aware of any changes made to the Bravo lights support.
If the test turn on the leds and Mobiflight receives a value of 1 from the sim or Fsuipc, the led should turn on.
shell fable
Yes both 0 and 1 results on the SimVar and Display tabs. Note that I am using m...
Not sure what you mean by both 0 and 1 on the Simvar and Display tabs. I asked for the Raw Value and Final Value. Ok, that is the name of the columns in the Beta. It is Flight Sim Value and Output in the the official 10.5.3 release.
In the main Mobiflight window
shell fable
I just want to make sure Mobiflight is receiving the values correctly from the sim.
normal dust
I'll check and get back to you.
full minnow
Jaime, I performed those tests and the values do change. But I found the issue. Seems that you cannot run Better Bravo Lights when using MBF. So I will need to use Mobi for all of the lights on the Bravo. Thanks.
ivory plume
yeah, two programs trying to access the same hardware at the same time leads to them fighting each other.
full minnow
Yes sir!