SDK vs FSUIPC | MobiFlight | Page 1

spare dagger Aug 8, 2025, 12:09 AM

#

Its been a bit since I've fired up some of my interfaces and saw that prosim is natively supported now. What advantages would I have switching from my current setup using FSUIPC to using the LVARS through the SDK here in mobiflight?

uneven crest Aug 8, 2025, 1:55 AM

#

spare dagger Its been a bit since I've fired up some of my interfaces and saw that prosim is ...

Hi Jason, I've almost fully migrated over to Prosim DataRefs and I'm finding the behavior of switches a whole lot more reliable. We are currently troubleshooting a few issues but for a non official release feature its really good. I'm back and forward with Prosim with a few issues but there resolving them.

spare dagger Aug 8, 2025, 1:59 AM

#

hello

uneven crest Aug 8, 2025, 2:01 AM

#

I would start with a fresh copy of Prosim loaded. I had a few issues going through and removing the the FSUIPC offsets back to "Not Connected". Some of the setting just wouldnt clear for me

spare dagger Aug 8, 2025, 2:02 AM

#

OK sounds good. I'm still assembling my cockpit...I had interfaced my overhead using mobiflight a few years ago so i will wait until I get everything else installed before I tinker with switching from fsuipc

uneven crest Aug 8, 2025, 2:03 AM

#

More more of trying to figure out bit and bytes. There is no more requirement to configure Prosim anymore except of Calibrating analog devices.

spare dagger Aug 8, 2025, 2:04 AM

#

nice.

#

WhatsApp_Image_2025-08-05_at_22.15.12_fccb194d.jpg

uneven crest Aug 8, 2025, 2:05 AM

#

Very nice. I'm trying to build mine mostly from scratch. Trying to work on the panel lightplates atm. What a pain.

spare dagger Aug 8, 2025, 2:05 AM

#

I have a little bit of everything. Sismo MIP, Opencockpits pedestal and aft overhead..mobiflight for ACP panels and forward overhead

#

Also mobiflight for standby gauges in MIP..so I will have to try to clean my config as it would be a PIA to start completely over.

uneven crest Aug 8, 2025, 2:07 AM

#

You might have to use FSUIPC for a few things still for customization but it's so much easier than trying to organize Offsets.

#

We are currently experiencting minor delays when flipping switches atm but the next beta wil fix that.

#SDK vs FSUIPC