rs1010 and double encoder

[cedar kernel]

hi guys, does anyone have the scheme for the rotary switch 2/3/4 position rs1010 and for the double encoder rotary? thanks

[alpine plover]

https://docs.mobiflight.com/devices/encoder/wiring/

it is generally good to look up the datasheet for the component. For aliexpress components many times the seller has a jpeg screenshot of the datasheet or if not, some other seller that lists the same component has.

[wise garden]

It seems the RS1010 rotary switch has an OFF position without connection. That can be complicated to use in Mobiflight, unless you avoid using that position.

[cedar kernel]

sorry for my late reply, thank you so much, tomorrow i try to connect 🙂

[cedar kernel]

do you have a wiring diagram? I wouldn't even know where to start because I've never wired one of these

[wise garden]

sorry I don't have any of those RS1010. I am going with what I saw in the datasheet. A multi position rotary with the first position being disconnected will not work well with Mobiflight, because there is no way to know when you turned to OFF.

using release of the first position does not tell you if you went to the second position or to off.

[wise garden]

rotary switches will normally have a set of pins, one for each position that you will wire each to an arduino pin and one common pin in the center that you will wire to GND.

[cedar kernel]

i wiring the double and it work, so really nice

[cedar kernel]

so what do you recommend I use instead of these?

[willow python]

I recently asked about this, see https://discord.com/channels/608690978081210392/1357731162323157122

[cedar kernel]

thanks

[wise garden]

RS16 or RS26 or RS25 should all work fine with Mobiflight, depending on what you need.