drowsy junco
Anyone issue with assign and then using it?
If i click on the top and then assign, and press than OK. If i want to test or use it, it doesnt work. If i want to test it, it comes this message (see pic. 2)
If i click on Run its stops directly
MSFS 2020
FenixA320
Assign a profile to the device
MobiFlight Connector 10.1.4
MiniCockpit Mini FCU (more infos see pic. 4)
drowsy junco
Anyone?
mint bramble
are you running the latest firmware version on the minifcu?
drowsy junco
I hope? Where do i find the firmware version that the mini fcu have? I will try it right now, after my bios updated. If this is the problem…. Oh man 🤦🏻.😅🥲🙈
mint bramble
I'm just guessing. There were firmware updates I think, and you moved to a beta. But I'm not familiar with the miniFCU. Don't they have a discord too you could ask in?
drowsy junco
Yeah im already in it. But they sayed i should paste it in here again. I will ask whats the newest firmware version.
So i tried to install the firmware and then again to upload the mobiflight minicockpit firmware but it doesnt work. It has the same problem....
drowsy junco
when i click on manage ophaned serials it says
when i try to make a new input it says in display cat. also this. Is this normal?
digital elbow
when you start Mobiflight the orphan serial dialog comes up only if there are serial numbers in your config which cannot be found in any of the connected boards. Is this your case?
drowsy junco
when i start mobiflight. It comes this message:
so i would klick on the sn 94g and press asign like the manual shows me right?
digital elbow
yes
drowsy junco
After pressign assign:
digital elbow
just press Ok
drowsy junco
if i press on OK and test the following "items" it shows me this:
digital elbow
maybe @terse horizon can help???
drowsy junco
i hope.... 😦
mortal sandal
if you show your MobiFlight Modules dialog, and screenshot that?
just to check it has all the buttons, leds and the lcd listed
drowsy junco
if you show your MobiFlight Modules dialog, and screenshot that?
How you mean?
drowsy junco
when i try to make a new input it says in display cat. also this. Is this normal...
this one?
mortal sandal
click the "mobiflight modules" button and you should see your minifcu device switches and displays etc there
mortal sandal
so just to see how that part looks - if the "SetCustomDevice" function fails, lets check the devices are there,
ok they are not, so click the "upload boards default config" button below the photo
erm
left click sorry
drowsy junco
ok i guess?
mortal sandal
oh ok
drowsy junco
should i press ok?
mortal sandal
yeah try
mortal sandal
sweet!
drowsy junco
but why. what have i done.
Oh. Maybe i know
This one is the replacement device. Could this be the problem?
mortal sandal
yeah likely
drowsy junco
oh wow..... thx very much!
mortal sandal
you are welcome!
