Servo,s Hoe to get small steps? | MobiFlight | Page 1

half radish Jan 11, 2024, 9:26 PM

#

Hello Al , I ,m building a attitude indicator as described by Captain BOB, 3D printer, assembling, all fine, configure the servo,s .all fine, connected to my Joke, pitch and roll, all fine BUT BUT
IN the MOBiFlight Test panel I can type in : 1, 0, -1 then the servo,s reacting, BUT in between, say 0.75 or 0,75, the servo,s keep in rest, same for the YOKE ACTION when roll or pitch is 1 or -1 then the servo,s reacting.
So I need some advice that the servo,s gently folow the numbers which are coming from the yoke.

thanks for answers,

Willie.

lethal sail Jan 11, 2024, 9:32 PM

#

half radish Hello Al , I ,m building a attitude indicator as described by Captain BOB, 3D pr...

Servo handling only accepts integer values, if necessary, multiply your sim variable times 100 or 255.

#

which simulator, which airplane, which event are you using for the servo?

half radish Jan 11, 2024, 9:36 PM

#

Hello Jaimi, thanks for your answer. multiply ? euh? how to do that?, I did some experiments on this without good results.

lethal sail Jan 11, 2024, 9:39 PM

#

show your output config to the servo. Math operations are done with a Transform.

#

@half radish

half radish Jan 11, 2024, 9:50 PM

#

find it back, the post

#

OK, will search for a tutorial how to fix that

#

oeps forgot to answer, my sim XP 11, cessna 172 and SG90 servo,s

lethal sail Jan 11, 2024, 9:56 PM

#

movement in a servo is proportional to the integer scale used. If you use a scale 0 to 1, then only two positions are possible, zero and full deflection. If you use 0 to 255, then 255 positions are possible.

#Servo,s Hoe to get small steps?