what do you mean by I tested the button contacts up to the Arduino board and tested with a second one, the tester detects the press...
a second arduino with MF firmware detects the button presses? If so, the issue is with one particular board?
#no more inputs and outputs work
vital temple
steep fulcrum
what do you mean by `I tested the button contacts up to the Arduino board and te...
excuse, google translate ^^
I use digital multimeter. On both arduino, the continuity test (between the input and the GND) show that the button working. So both arduino detect when i press the button.
But nothing is detected by MF when is running. Nothing in the log and in the sim...
sick bear
restart MF and PC
vital temple
back to basics, does Windows detect the arduino, does arduino IDE detect this arduino? What type of board is it? Original or chinese clone?
steep fulcrum
both detected by windows and detected by IDE. Original Arduino !
vital temple
does Mobiflight detect the board ok when starting up?
as a Mobiflight Module
original arduino which type? do you have anything connected on pins 0 or 1?
can you load the blink sketch with the arduino IDE and works ok?
steep fulcrum
original arduino which type? do you have anything connected on pins 0 or 1?
Arduino Mega and nothing on pins 0 and 1
steep fulcrum
can you load the blink sketch with the arduino IDE and works ok?
I will try
vital temple
You didn't answer if Mobiflight detects your board as a Mega with the arduino firmware installed.
What does Mobiflight Modules show about this board?
steep fulcrum
with MF Firmware...
nothing when test button is press...
just reset the board wiht MF, I don't know how upload informations via IDE...
but IDE see the board as an Arduino Mega
vital temple
but IDE see the board as an Arduino Mega
and are you absolutely sure the button device config has the correct pin used in wiring the switch button?
make sure to close the IDE before starting Mobiflight