I don't know anything about configuring the KAV display. Have you installed FenixQuartz? Since Fenix does not provide any variables for the FCU displays, this app is requried to be able to display the Fenix A320 FCU numbers. It extracts the data from the Fenix/Prosim app that runs in the background.
#Fenix FCU -KAV Profile question
formal portal
wide canopy
Yes I used Fenix Quartz
For example the speed is actually Dashed ! When I rotate the knob the dashes must be disappear and the numbers must be showed up . After some seconds the numbers disaberas and the dashes showed up .. ###her is a short video what I mean
When I go out of managed mode the numbers shows normal
formal portal
When I go out of managed mode the numbers shows normal
without having seen your output configs it is only speculation. the dashed lvar seems to correctly give control back to the number display config, but the number display config is not being activated. If using preconditions for this, you need to check that they are truly mutually exclusive. That is, when one is on the other is off. In this case it appears like both are off at the same time.
formal portal
some parts ive fixed but there are many issues left
I took a quick look at your file. The first thing I would comment about is the FCU - SPD Value output config. You are over specifying with four preconditions that are not really independent. There is no need to do that.
The last three out of the four preconditions are not independedent. There is no way to have a MACH value greater than 100 if the SPD mode is NOT in Knots. The SPD label config and the MACH label config both read the same sim variable, so there is no way for one not to be the inverse of the other, and they indicate the active mode in the same way as the second precondition. Therefore, you really only need one of those three preconditions. I suggest you delete the last two.
wide canopy
ok thank you very much 🙂 ive tested yesterday the whole day .. now its works properly , but n didnt work ,,, when i climp above Fl260 its autmaticly jumps to MACH and the dashed must shows -.-- but it only shows --- . when i delete one of these it doesnt work ... thats strange on FBW are only 1 or 2 Preconds. only with fenix i need more
formal portal
TBH I don't use preconditions to do the change from numbers to dashes. I do all that with Transforms and Compare. I tend to use precondiitions only if there is no other way.
wide canopy
Thats my actual semi working Profile .. the FCU parts under the Overhead part ... i miss the sorting feature 😂