roll and yaw reversed

[scenic ocean]

I've been watching videos forabout a week now and was starting to get somewhere , then things started going wrong so i decided to reload my models , right now i've reflashed both transmitter and nexus xr and no matter what i do roll and yaw are on the wrong sticks, i've changed from mode1 to mode 2 and 3 and 4 and back to 2 but its still wrong, I've spent so much time trying to figure tis out but i'm getting nowhere, what do i need to do?

[weak condor]

✨AI-Generated response✨

This issue usually stems from the channel map order in your radio handset mixer or flight controller settings. Ensure your radio is set to Mode 2 and your mixer matches the expected order (AETR). In Betaflight or INAV, verify the "Channel Map" matches your transmitter output.

Also, make sure you have disabled the ADC Filter in your radio's Hardware settings, as it can cause jagged command data. For further radio instructions, see the radio preparation guide.

---

please follow up in #help-and-support or #general-quad-help

-# {'cause': 'thread creation'}

[remote bear]

roll and yaw are on the wrong sticks
how so? what mode do you want to use?
how are they wrong for the current mode selected?

after changing the mode, did you created a new model?
in rotorflight, did you checked the channel mapping is correct per your mixes configuration in the radio?

[scenic ocean]

i want to use mode 2, no i didn't make a new model after changing mode, but i did power cycle it in case that had an affect, it didn't, i did eventually sort it out i believe but it envolved swapping the channels around in the transmitter and renaming the channels, it seems to be working now but i will need to double check eveything tomorrow,

i do have another query, i'm using a yge aureus 135 esc, i have telemetry set to open yge in both the esc and rf, everything is reading (now) but rpm is completely wrong, i have the gear ratio's set in the esc and in the rf companion but i have to turn off rpm sensor in the motor section to get it to read anything, so the gear ratio isn't being used, where should i look to correct this?

this will of course be tomorrow as its late and im off to bed

[remote bear]

unfortunately, I'm not familiar with this particular set up.
expressLRS is mainly a transport for the telemetry data. it basically just "carry" what the receiver has and send it back to the handset.

so either it's something on your flight controller settings (rotorflight) or in edgeTX

[scenic ocean]

it appears that it is correct in the transmitter but not in the companion, good enough for me, i did maiden it today and it was horrible, the tail is so soft and mushy, so next up on the agenda is how to tune the nexus fbl , i know its way better than this

[wicked holly]

Can I ask what RX and TX you're using for this set up? I can't seem to get telemetry from the ESC

[scenic ocean]

tx15 and nexus