Drone doesn't react to the movement of the stick

[strong trout]

Hi! Please help
The drone does not respond to the movement of the remote control joystick ( Radiomaster TX12 )
The drone is connected to the remote control, the signal is stable and good
The problem started after I connected the pilot to another drone
ExpressLRS on drone and remote version 3.3.0
In betafly, the receiver is selected Serial (via UART), CRSF
the Ports tab for UART1 is selected Serial Rx antenna is connected to UART1 the current is normal on the drone
Binding Phrase same on drone and controller

Tried flashing TX and RX

[sonic flicker]

post a screenshot of the ExpressLRS Lua Script with the TX and RX bound/connected

also post a screenshot of Ports Tab and a photo of the actual receiver wiring to FC..

also, what vtx do you have on this drone? dji? analog? walksnail?

[strong trout]

Camera and VTX Option: Analog
Version : Darwin "Cement" Waterproof CAM+600mWAnalogVTXHD Version : RUNCAM LINK Wasp

actual receiver wiring to FC

[sonic flicker]

which VTX do you actually have?
Runcam Link/Wasp is digital, and if it has the SBUS wire connected to FC, then that'll be a source of your issue

[strong trout]

I'll check, but unlikely.
Last week all was working fine

[sonic flicker]

on the lua script, while tx and rx are bound/connected, set Model Match to On, then set it back to Off after a few seconds