#what's happening when I try to arm my drone?
60 messages ยท Page 1 of 1 (latest)
what does the OSD say?
or:
connect drone to betaflight configurator, with LiPo plugged in
go into the CLI Tab
arm
type in the command status press enter
post the output here
disarm
make sure your throttle channel is at minimum/all the way down
BEFORE you arm
but were your sticks calibrated?
can you also post a screenshot of the Receiver Tab, particularly the right hand side sections
also, does the preview of the drone in Receiver Tab staying still with tx and rx bound/connected?
well, "stick Low" is set to 0
stick center is set to 0 as well
and stick high is set to 255
values for these should be
1005 or 1010
1500
1995 or 1990
respectively
also disable RSSI ADC
I have
989
1465
2012
values for these should be
1005 or 1010
1500
1995 or 1990
On concrete position?
Like when stick down it must be 1005 or 1010
In center 1500
And high 1995 or 1990
That's you mean?
Or where i need to find this?
Here i need to write those values?
Ok
Och
Its working
Thank you very much
But also i have more next problem's
๐
Do you have more patience?)
state the problem
Yes but when i armed drone its not going anywhere
after you disarm, once you're done with the flight stats, dismiss it by flicking the pitch stick upwards
arm
fly
disarm
flight stats appear
flick pitch stick upwards
flight stats disappear
Oh i think i do exactly what you tell
But it not wark
And i just restart drone
And its wark
Work
Soo... Next question)
I also had open theme in #1033101924494487582 its calls poor connect quality
I have post a comment in that thread
is rssi adc bad?
I was enabling telemetry in betaflight, and I toggled it too
it makes Betaflight use analog RSSI input to show signal strength instead of the RSSI/LQ data that ELRS provides via CRSF
which, in the vast majority of cases, means that it shows useless data
ahh okay
you need to have it turned OFF to see the real RSSI/LQ @daring gyro
okay, will do