#Trouble updating HM Tx 2.4 pro.
wild shale
THANK YOU SIR! i knew i read something about this in the past. but had no issues with older firmware so i didnt mess with it until now. much appreciated for the swift response.
wild shale
I have successfully flashed my hardware to 3.2. im going back through and attempting to bind previous drones that are using elrs and nothing is showing on my stick commands? any ideas what to look for? i double checked my ports tab. i assumed updating these would have been straight forward since they worked without issue before . i am bound to a ep2. shows full connection on transmitter but nothing on the stick commands. Any ideas? thanks
unborn finch
I have successfully flashed my hardware to 3.2. im going back through and attemp...
set model match to Off, if it's On
if it's Off, set it briefly to On, then set it back to Off after a second..
Model Match is in the ExpressLRS Lua Script
wild shale
set model match to Off, if it's On
if it's Off, set it briefly to On, then set i...
unfortunately, it didn't work. I've noticed it's also not binding to any of my elrs AIO that are SPI based. seems something is wrong since the update. il let you know if I figure if im able to figure it out... I'm pretty confused now; wasnt expecting this many hurdles. total bummer.
unborn finch
!spi
uneven agateBOT
https://www.expresslrs.org/3.0/hardware/spi-receivers/
Flight controllers with built-in ELRS SPI receivers are not flashed using ELRS Configurator, the ELRS firmware is "baked in" to Betaflight. Thus to update your ELRS firmware, you'll need to flash the latest version of Betaflight for your FC. Betaflight 4.3.x is compatible with ELRS v2.x.x, and Betaflight 4.4.x is compatible with ELRS v3.x.x.
To set a binding phrase on a SPI receiver, enter it here and paste the resulting code in the Betaflight CLI: https://www.expresslrs.org/3.0/hardware/spi-receivers/#binding-phrase
unborn finch
a C in the top right corner of the ExpressLRS Lua Script means the receiver and tx module is bound together
wild shale
a C in the top right corner of the ExpressLRS Lua Script means the receiver and ...
yes sir on the ep2 it shows the C on the right corner. just can't get any stick commands on betaflight. ive double checked ports tabs and receiver protol everything looks to be where it should. I did read the spi section. normally i had success using the old firmware
i just updated BF and the FC firmware with same results.
unborn finch
yes sir on the ep2 it shows the C on the right corner. just can't get any stick ...
did the EP2 worked on earlier versions in this exact same flight controller/uart setup?
wild shale
yes sir the ep2 and Spi were both working previous to update. that's why im kinda confused. I assumed it would transfer over easily. il continue reading. il keep you updated. thanks for the help.
wild shale
i just asked another one of my friends he mentioned having the exact same problem and not being able to figure it out and gave up after a while. This explains why hes not using elrs anymore.