Jumper T Pro Flash Error | ExpressLRS Community | Page 1

tender geyser Oct 28, 2022, 2:04 PM

#

please post the log

#

!log

arctic cloudBOT Oct 28, 2022, 2:04 PM

#

See the following image to save a log file from the configurator

#

https://cdn.discordapp.com/attachments/798006228450017290/1025339571979960340/LogSaveToFile.jpg

digital sentinel Oct 28, 2022, 2:06 PM

#

📎 ExpressLRSBuildLog_20221028140605852.txt

tender geyser Oct 28, 2022, 2:07 PM

#

digital sentinel

did you followed the flashing guide?

#

i.e. there's a button you need to press at the right time

#

(via ETX Passthrough is only used for recovery flash on the T-pro because you need to open up the radio

#

https://www.expresslrs.org/3.0/quick-start/transmitters/aion-internal/#recovery-method-via-edgetx-passthrough

Internal Jumper T-Pro - ExpressLRS

ExpressLRS aims to provide the best completely open, high refresh radio control link while maintaining a maximum achievable range at that rate with low latency. Vast support of hardware in both 900 MHz and 2.4 GHz frequencies.

digital sentinel Oct 28, 2022, 2:08 PM

#

oh, should i just do it through wifi then?

tender geyser Oct 28, 2022, 2:09 PM

#

digital sentinel oh, should i just do it through wifi then?

via wifi is the recommended method.. as that doesn't require that you open up the radio

digital sentinel Oct 28, 2022, 2:09 PM

#

ok sounds good ill try it

digital sentinel Oct 28, 2022, 5:06 PM

#

Got everything working, The original problem that i was having which made me buy the t pro is still happening but its some sort of drone/beta flight problem not elrs i guess

#

its a protek r25 and sometimes when i let off throttle and go to 0% it stays at a higher throttle thats enough for it to hover, sometimes it stays at like 80% and i start to climb :/

#Jumper T Pro Flash Error