BetaFPV 915 rx wouldnt accept firmware so i used the repartitioner firmware. now rx is stuck with solid blue light, cant load 3.01 firmware onto it using wifi or ftdi adapter. what do i do?
#ELRS RX wont go into bootloader mode
fathom heart
humble robin
repartitioner is for Tx only
reflash following the recovery procedure
!recovery
crystal wadiBOT
Follow these steps to recover a bricked RX:
- Move the 5v wire going to the receiver to a 5V pad that only powers on when a LiPo is connected
- Disable Telemetry in Betaflight
- Save and Reboot
- Close Betaflight Configurator and unplug USB and LiPo
- Bridge the boot pads or hold down the boot button on the receiver
- Plug in USB
- Click "Build and Flash" in the ExpressLRS Configurator, selecting via Betaflight Passthrough method
- Wait for the line PASSTHROUGH DONE to appear
- Plug in LiPo (with boot button held down/bridged)
- Wait for the process to finish (with success hopefully)
- Unplug everything, unbridge the boot pads, then power on to confirm the LED blinks, and then goes into WiFi mode
Video Tutorial: https://www.youtube.com/watch?v=jYLwaWBkM_A
fathom heart
so i hold the button down the whole time after powering it on till finished or just when powering it on? and is the light suppose to change at all it just stays solid blue never blinks
humble robin
so i hold the button down the whole time after powering it on till finished or j...
you can press and hold the button during power up, then you can release it, and flash..
fathom heart
ok ill try it again