First layer was good and the second layer is crashing into the first layer | Rat Rig Community [Unofficial] | Page 1

little cosmosBOT Jun 29, 2025, 2:37 PM

#

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

uneven fractal Jun 29, 2025, 2:57 PM

#

Over-extrusion maybe? First layer looks okay cause the offset is too high to compensate perhaps

junior siren Jun 29, 2025, 5:19 PM

#

it also sound like the nozzel is crashing into the bed plate

uneven fractal Jun 29, 2025, 5:26 PM

#

Measure the height of the head, command it to move 100mm away from the bed, re-measure. Double check that it's moving the right amount?

junior siren Jun 30, 2025, 3:15 PM

#

i tried to print a big benchy 2times and it looks very similar and same problems the front side shift a little bit higher than rest.

#

#

i dont think that its a over extrusion

junior siren Jul 1, 2025, 3:47 AM

#

@uneven fractal

#First layer was good and the second layer is crashing into the first layer