If you think it’s a motor driver swap drivers with another one on your board and test again.
#Major issue with print now printer homes incorrectly in the y axis
west spoke
cyan crag
i had this issue on a new build - turns out i had inadvertently swapped left & right motor connections
twilit tundra
i had this issue on a new build - turns out i had inadvertently swapped left & r...
I saw that answer before but I didn’t unplug or change anything from the board, nor steppers but worth a shot. Ty
twilit tundra
Wanted to nke this thread, but I'm an idiot. I have been woking on my VCore3's for the past week and all of the homign was to the rear. Its on the front on a VC4😭