#Negative temp readings from Octopus V1.1 F446

23 messages · Page 1 of 1 (latest)

fallen flare
#

So, I just bought a VC4 500 Idex, everything was fine, when i plugged in the eletronics fan, after some time, i noticed my Octopus V1.1 F446 was reading negative, and the controller was always active even tho it says 0%.

It's connected to PD12 with 24V jumper.

image.png image.png
limber sigilBOT
#

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

bitter totem
#

Drop your ratos.cfg and printer.cfg please.

fallen flare
#

@bitter totem

fallen flare
#

Negative temp readings from Octopus V1.1 F446

bitter totem
#

Have you updated ratos? I'm wondering if this was a pin issue that has since been fixed. Ratos and printer configs seem fine, in ratos.cfg the sensor type also seems right:

sensor_type: temperature_mcu```
#

leaning towards a faulty board for the temp issue at least

#

Update ratos, re-run through the configurator.

fallen flare
#

nothing changed

bitter totem
#

Weird. The mcu temp is built into the board, tough to get that wrong :/

#

are you 159% sure you have a F446?

fallen flare
#

It was working normally until I plugged the electronics box fan

#

I already contacted ratrig trough the contact form.
2 options:
faulty board or fried

bitter totem
#

I agree that's your best choice at this moment

fallen flare
bitter totem
#

Sorry it wasn't more immediately successful. Learned about the temperature_mcu sensor_type too 😄

fallen flare
#

New board fixed it.

#

The other one was fried

#

@bitter totem