Wait for DFU after flashing - Octopus Pro 1.1 H723 | Rat Rig Community [Unofficial] | Page 1

timid shell Jan 4, 2025, 10:22 PM

#

I have flashed the firmware, no jumper is on the board.
After the flash, the DFU is not detected.

I am running the board on 24V, motors 48V, the DFU jumper has been removed

tired solsticeBOT Jan 4, 2025, 10:22 PM

#

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

timid shell Jan 4, 2025, 10:23 PM

#

I have created this new ticket, but it seems to refer to the same issue that was found here: https://discord.com/channels/582187371529764864/1275256832155193376

placid acorn Jan 4, 2025, 10:23 PM

#

i think you are using the wrong board in the configurator

#

I believe there is another pro 1.1 in there

#

If the pins in the configurator do not line up with what you have, you have the wrong board selected

timid shell Jan 4, 2025, 10:29 PM

#

What do you mean ? pin layout is matching

#

placid acorn Jan 4, 2025, 10:31 PM

#

Have you done:
Place boot pin
press reset(should show up for DFU)
Remove boot pin
Flash

#

And if so, have you tried again? 😅

timid shell Jan 4, 2025, 10:32 PM

#

It flash the firmware, but after there is no detection, I have flashed 4 times already

placid acorn Jan 4, 2025, 10:34 PM

#

Hm. Interesting. Maybe power cycle everything and try again?

#

Otherwise Im low on ideas :(

timid shell Jan 4, 2025, 10:37 PM

#

I am rebooting everything now. if it does not work, maybe the firmware uploaded by DFU is corrupted

#

OK, it is solved!

#

So for the Octopus Pro V1.1 H723, the solution is to flash and reboot the whole system

tired solsticeBOT Jan 4, 2025, 10:41 PM

#

Thank you for marking this question as solved!

Learn more

#Wait for DFU after flashing - Octopus Pro 1.1 H723