bold turtle
Hi guys i can´t figure out why my ocotopus is not switching the ssr anymore
i have 5 days and 5 hours on my vcore 4 500 hybrid, worked flawlessly
it suddenly stopped working during a print " bed not heating at expected rate"
the ssr works i tested it with a power supply
The cables are all good i checked them and also measured
The Fuse is also good
But the octopus is not giving power to it
dense stagBOT
bold turtle
the polarity is correct
And i already changed the octopos to a new one because i had it on hand
bold turtle
i tried switching the pin
[heater_bed]
heater_pin: PA2
this pin is also not turning on
Motion system is working
tried reflashing the board, didn´t change anything
tough rover
Did you check with your hand if the bed gets warm?
Maybe its just the thermistor wich is bad? Otherwise its the bed heater itself according to your checks
bold turtle
no
the ssr has a status led that doesnt turn on
when i power it directly it turns on and gets warm
tough rover
Did you though of replacing the wires? Wich lead to the ssr?
bold turtle
I put 24v at the crimped ends and it worked so no i did not change the wires
Is there a way to manually switch PA1 on on the octopus?
woven tusk
Do you have a multimeter/voltmeter?
minor laurel