TMC ‘extruder’ reports GSAT | Rat Rig Community [Unofficial] | Page 1

woeful flicker Oct 31, 2024, 8:34 PM

#

Hello,

My printer keeps throwing this error at 95% or so of a 24 hour long print. I attached a picture below to show. Any idea what’s causing this? I checked my wiring and it’s all fine looking. Also, the print started looking bad before this error. And ideas?

stone epochBOT Oct 31, 2024, 8:34 PM

#

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

woeful flicker Nov 2, 2024, 1:27 AM

#

Anybody?

quaint cloak Nov 2, 2024, 7:51 AM

#

this looks like a bad crimp

#

this is a connection or shorting issue

woeful flicker Nov 3, 2024, 11:50 PM

#

ok thanks

untold prism Oct 7, 2025, 12:14 AM

#

@woeful flicker where you ever able to fidgure out this issue?

woeful flicker Oct 7, 2025, 1:17 AM

#

untold prism <@716857814152249397> where you ever able to fidgure out this issue?

Yep. Was a bad connector. Put a new one on and good as new. Had the issue also where pin wasn’t fully in the socket. Using some silicone glue to hold it in made a big difference. I have thousands of hours no without issue

untold prism Oct 7, 2025, 1:18 AM

#

If you dont mind me asking what connector?

untold prism Oct 7, 2025, 1:18 AM

#

woeful flicker Yep. Was a bad connector. Put a new one on and good as new. Had the issue also w...

And just like hot glue?

#TMC ‘extruder’ reports GSAT