Move out of range error on Initial bed mesh set up

[mellow minnow]

I just finished building my v core 4 Idex today and was trying to go through the commissioning guide. When I attempted to do the first bed mesh I got the following error that haults my progess:

Move out of range: 495.311 25.000 2.000 [0.000]

The head scans the front of the bed but then stops and prints this error. What should I check to find what I did wrong?

[rare bloom]

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

[viscid ocean]

how big is your printer?

[mellow minnow]

500mm

[viscid ocean]

probe_count: 25,25```

try this

@austere brook havent we tested the y directed mesh for idex already internally?

[mellow minnow]

I had installed Ratos RC2 a few days ago and when I started to look at the update manager I fond that there was an update for Ratos. After I updated it ran the bed mesh perfectly first try.

[viscid ocean]

nice

[mellow minnow]

is this a skewed frame? it looks like my bed is really not flat

[viscid ocean]

show the data on the right side

this graphic can be misleading, depending on the visualization settings

[viscid ocean]

show the data on the right side

[mellow minnow]

Like this?

[viscid ocean]

just show the whole screen

[mellow minnow]

Nevermind I understand

[viscid ocean]

0.6 is a bit height for a 500

but you can totally use ti already

its not too bad

but you could most likely improve it a bit

[mellow minnow]

Would I improve it by adjusting the skew>

[viscid ocean]

make a mesh when the printer is cold

and bassed on that mesh you can improve it

[mellow minnow]

this is cold

[viscid ocean]

looks like its a bit skewed on the back

[mellow minnow]

ok thank you, Ill follow the video on the guide from here

[viscid ocean]

right back a bit down or left back a bit up

also make sure to make a ztilt before doing the mesh

[austere brook]

Yes, @mellow minnow please make sure you update everything.