VC4 500 Just to be here

[brittle cypress]

Just starting a thread for if I do need help.

[dusky hornet]

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

[brittle cypress]

this is good?

[hoary elk]

You got 2 peaks that match that is great in general. You got noise of course, you can see it because its not a sharp curve, but run IS graphs and see how they look like.

[brittle cypress]

not really sure what im supposed to be looking for here.

[half anchor]

You're looking decent. I personally would move forward then rerun them after 24 hours of printing. Things might settle into place between all the movements and heating/cooling.https://www.youtube.com/watch?v=M-yc_XM8sP4

[brittle cypress]

this is my Y graph

is that good? lol

[half anchor]

Yes that looks like it will work just fine. Do your commissioning again after 24 hours of printing especially if you print hot (ASA, ABS and what not) as the heating and cooling will make parts settle into place.

Skip the corexy belt tension test though if you have hybrid. Apparently it is useless once you add the other belts.

Given your accelerations though, I’m assuming you have hybrid as mine ended up at 5500 when I recommissioned.

[brittle cypress]

It's hybrid and 48 volts

[spark orbit]

Hello 😊 what do you did to come from this to the next post ?

I have a problem with my belts 😁

[brittle cypress]

tighten your lower