quartz laurel
Hey guys I have had issues today.
So loaded the RatOS to a 64gb SAN DISC card that went fine, talk to the BTT and loading its firmware went to say that the firmware is decteded but unresponsive any idea what this can mean here is a photo of my BTT boards numbers.
Note that the BTT SD card is a 32gb and i formatted it to the FAT32 with 8kb yes .
modest lake
Did the extension of the firmware file change?
quartz laurel
This for you are meaning from .bin to cur yes ?
If so then yes but it’s odd that my raspberry pi isn’t hosting a hotspot anymore
quartz laurel
For the pi to do the config right does a lan cable have to be plugged in for the first start up or can it be WiFi ?
modest lake
Wifi will work on first boot, no need for Ethernet cable
quartz laurel
Okay and after the RATOS has connected to the conifig page it will dispear yea?
modest lake
Once you have it connected to your home wifi, it will stop putting out it's own hotspot, correct
quartz laurel
👍
modest lake
What happens when you do "flash again"?
modest lake
not terribly likely. Have you tried flashing it manually with a microSD card?
lean quiver
try the steps from "how to recover from a hard reset" in https://discord.com/channels/582187371529764864/1233461645167169576
I suspect you did a hard reset and that is why this is messed up
modest lake
Yes. Step 1 being "log into your pi" that is usually done via ssh.
modest lake
If you knew enough to ask the question, you know enough to use it honestly. It's pretty simple. What terminal are you using?
quartz laurel
Terminal ?
I have watched someone login but don’t know ssh runner or how to use it
quartz laurel
It would be a windows command prompt I guess cuz that’s what I’m using to do the setup
Windows 11
modest lake
Okay, so do a ssh [email protected]
or if you have the IP of the pi, ssh [email protected] (replace the x's with the IP)
quartz laurel
I can try get the up
So what I set the os when setting up the rat os I use that with the pi@(what i set the username to be ).local yea ?
And I do this via windows command prompt ?
granite saffron
Username is pi and PW is raspberry
quartz laurel
Okay I didn’t reset that yet so that should work
modest lake
pi is the username. So it is like who@where
You're trying to login as pi, and the machine is at ip.
quartz laurel
Alright I will try this tomorrow night I’m really confused by all this
modest lake
Good luck, I'll keep trying to help
quartz laurel
Thanks man
Maybe if you one tomorrow round about some time we can hop into a call
If you’re okay with that ?
Same*
modest lake
I work from home so ping me when you're around and I can try
quartz laurel
Oh sweet thanks man
lean quiver
Alright I will try this tomorrow night I’m really confused by all this
if it is easier, just reinstall ratos. Then on refresh all the dependencies on the mainsail interface. if it says corrupt - ignore it and keep hitting refresh as the first time it needs to connect to the internet and until then it incorrectly says "corrupt"
modest lake
^
lean quiver
and in general, if it ever asks you to do a hard reset the answer is NO
quartz laurel
Okay thanks
