1mm nozzle prime blob dangerously big

[daring peak]

Hi guys, I'm just trying out a 1mm nozzle. Prime blob seemed fine until I set the nozzle to 1mm in ratos because mid print I got the extrusion limit error because the printer was probably still in 0.4 nozzle mode.

[rough fjord]

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

[daring peak]

I reverted the nozzle setting in my printer.cfg and went for the max_extrude_cross_section setting that I increased to 50. Blob seems to print normal again

[bronze lily]

is your rotation distance on the Z Axis right?

[daring peak]

Yes that seems correct, never changed anything there. It's printing fine now with removing the 1mm nozzle from my printer.cfg

and adding the max extrude cross section command at 50

[dense prairie]

Looks like the equation to calculate the extruded amount might be a little off 😂

[dense prairie]

Did the bridging afterwards work fine? Ie is the size of the blob the only issue

I can make sense of that (i'm multiplying all of the extrusion lengths currently, probably don't need to scale the blob over a certain size)

in fact it should probably be the same size always

[daring peak]

I haven't ran it further with those settings, I removed the nozzle from my cfg and added the cross section limit, after that everything seems to work as expected

[dense prairie]

I haven't ran it further with those settings
I meant the bridge from the blob, looks OK in your pic.

But the fact it's working OK with a 0.4mm configured confirms that we don't need to scale blob size, only the way it's extruded.