RatOS and PT1000 B Thermistor

[honest ibex]

Hello There. I just got a new Rapido Hotend and it is a PT1000B rather than a 104NT-4 like my old one. Can someone help me with what I need to change in the printer config to update this? The current RatOS Rapido.cfg uses “sensor type: ATC Semitic 104GT-2”.

Additionally, I am plugging it into an EBB36 1.2 and have it plug into the TH0 port right now. Since there is only 2 wires, I was unsure if I could use the PT1000 port on the right side of the EBB36 pinout.

Thank you for taking the time to read this!

[devout matrix]

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

[novel apex]

[extruder]
sensor_type: PT1000

[honest ibex]

Thank you! I am using an EBB36 right now with it, and am using the TH0 pins. Is this okay?

[novel apex]

Yes :). If you put in the PT1000 jumper you’re gonna need ‘pullup_resistor: 2200’ as well. Putting that jumper on increases the accuracy of the PT1000.