Klipper fails after hard Recovery | Rat Rig Community [Unofficial] | Page 1

stuck vessel Apr 23, 2024, 5:23 PM

#

Hey all,

After clicking hard recovery for klipper on Mainsail, Klipper won´t run again (Section 'ratos_homing' is not a valid config section). I´ve seen the help article (https://os.ratrig.com/docs/troubleshooting/) but can´t follw the steps. When using it´s IP/configure I get "error 502 Bad Gateway". RatOs.Local/configure was broken on my machine since I got it. Starting it without internet connection wont help - same problem there when trying to configure the machine. Is there any way to get around this issue (hopefully excluding a complete reinstall)?

Thanks a lot!

Troubleshooting | RatOS

My steppers are running backwards!

placid nacelleBOT Apr 23, 2024, 5:23 PM

#

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

pulsar trail Apr 30, 2024, 10:44 AM

#

I AM GETTING THE SAME ERROR

tacit orchid Apr 30, 2024, 1:25 PM

#

When using it´s IP/configure I get "error 502 Bad Gateway"
That's when you just try to reach that page, or after you press "Symlink klippy extensions"?

stuck vessel May 2, 2024, 12:02 PM

#

tacit orchid > When using it´s IP/configure I get "error 502 Bad Gateway" That's when you jus...

When trying to reach that page.

Afterall I did two full reinstalls. After the first one I made all the Updates and ran into the same problem.

On the second try I left out the Klipper and RatOS Updates and waited for new releases before updating. Not a satisfying solution, but worked for me and narrowed the origin of the error down ^^

#Klipper fails after hard Recovery