spiral raft
I'm having an issue where my x endstop is always showing as triggered in Klipper. The endstop light turns on when pressed, but seems not to register the input.
I'm following this ↓ wiring diagram for the octopus.
I've replaced the wire because I thought the the other one was getting hot - and, because I had to flip the wire. With the new wire (pictured) I still can't get it to work, so I can't tell if it's a hardware or software issue.
Thanks for any input, I really appreciate it.
echo basin
I'm having an issue where my x endstop is always showing as triggered in Klipper...
Are you able to share your printer.cfg file? Also it seems like either the black cable is not crimped correctly, or the connector isn´t correctly seated in the casing. You should not be able to see bare wire here:
The crimp connection should look like this, where the rear part of the crimp connector is clamping onto the wire insulation. Have a look at this guide for more information: https://www.instructables.com/Make-a-Good-Dupont-Pin-Crimp-EVERY-TIME/
