I have a BTT 5" touch which as working after doing the new install its dead. I may have damaged the HDMI micro port ,even if i do not see any thing out of order. Is there a way to try the other port of reinstall only klipper screen?
#Klipper Screen not working.
vital parcel
slim groveBOT
languid sage
Does your screen show the console when the rpi is booting?
if not its not klipperscreen...
You can also put it in the other port, but you need to restart the pi as well.
vital parcel
Is there a way to check that klipper screen is installed correctly? or a way to reinstall it?
languid sage
over the web interface in the machine tab, you can update klipperscreen, restart it and reinstall it.
However when the screen doesnt even show the bootscreen when the pi boots, then klipperscreen is not the problem.
Either your screen is broken (check with another hdmi monitor for example), your cable or your pi.
You can also check your BTT screen with another device, forexample your PC or something if it outputs anything.
vital parcel
Is it normal that the klipperscreen.conf is empty?
the screen works perfectly with my pc.
I tried 2 new cables
vital parcel
Seems that if the HDMI0 is broken you can not use the HDMI1. So if I have to get a new board which would be the best board to buy.
Or solution.
languid sage
I think mine also showed at least the boot screen on the pi on both HDMI ports,
but I'm not at home atm to confirm.
Did you check the pi with a different monitor? I would do that before I buy a new one.
I got a Pi4 with 1GB ram which is enough for klipper
languid sage
Is it normal that the klipperscreen.conf is empty?
No.
vital parcel
Can you please send me your file to see how it should look like. When you have time. I have the CB1 mounted on the manta m8p.
vital parcel
Ok solved I dismounted the board to take a close look to see it the HDMI0 was broken but It wasn't looking closer something had fallen into the connector. I used a needle and popped it out. Put back in the cable turned it on and it is working perfetly.