X and Y motor axis confused even after swapping wires on mainboard

[mint fern]

Whenever I home the printer the x-axis homes correctly and when the y gantry hits the switch the led turns green but the gantry mashes itself into the switch.

[azure bobcat]

To help others find answers, you can mark your question as solved via Right click solution message -> Apps -> ✅ Mark Solution

[quasi wing]

Check the endstop state on your machine tab and double check your wiring of the endstop. I killed with a incorrect wiring one of my endstop ports because I did not pay attention. See the pinout for the endstop here #v-core-3 message.

If the endstop port is dead it will be always triggered and you have to use a new port.
To do so you have then to provide the new endstop port pin for the y axes in you overwrite section in your printer.cfg here a example:

[stepper_y]
endstop_pin: ^PG13

Good luck.

[mint fern]

so heres the thing. The endstop reports the correct state when tested. Open when not pressed and triggers when tested. So its confusing to home the machine and see the y gantry hit the switch and never stop the motors

[mint fern]

and my wiring is correct

[gentle wing]

What about all the jumpers under your drivers?

[mint fern]

i took them out as i was instructed to in the manual

except the one second to last on the bottom

okay

im finding something out

Okay I found something very odd

This no longer seems like an endstop issue

I verified that my steppers move the correct direction last night and now they are moving completely wrong. When I move x axis the printer moves the y axis and vice versa

X and Y motor axis confused even after swapping wires on mainboard

I moved the cables around thinking I had it wrong but it still doesn't fix the issue

[mint fern]

This is very odd knowing the fact that it worked last night and I havent changed anything other than adding the extruder sensor and 4028 fan