#PLEASE HELP 0.671mm range
honest moat
honest moat
this is without magnet or pei
drowsy elm
You see that the back left corner is quite high. So if you adjust the front left upwards a little bit, it will likely improve it
honest moat
ok so im pretty sure the bed must be bent right
i tried retightening the y liner rails and tweaking the frame the best i could and this is the result
what else could be causing the big dip in the middle?
the bed is not heated up and the magnet is not applied
honest moat
PLEASE HELP 0.671mm range
drowsy elm
Likely the bed is not warped, but the X gantry is a bit
That is quite normal, especially on a large machine
What you can try, is to heat up the bed and let the gantry heat soak for a bit (like 15 to 30 minutes)
And then run a mesh again
honest moat
the bed is warped
i contacted ratrig website support
i placed a 2020 on the bed that i confirmed is perfectly straight and i can see a lot of light under it
sadly i was unlucky on the heated bed lotery
luckly i didnt apply the magnet or heater yet
i would say its significantly bent
honest moat
Likely the bed is not warped, but the X gantry is a bit
you can see its warped along the y not x
drowsy elm
If that 2020 is indeed perfectly straight you could indeed have been quite unlucky
honest moat
If that 2020 is indeed perfectly straight you could indeed have been quite unluc...
yup
drowsy elm
you can see its warped along the y not x
Ah yes you're right, I missed that 😅
I hope support can help you further!