Move out of range: 553.863 142.883 0.484 [111604.695]
Occurs at start of print after prime blob. I cannot figure out why it wants to go beyond 500, bounds are set correct in slicer and config, looking inside the G-code cannot find anything suspicious. G-code attached.
#[solved] Move out of range at start of print
glossy stirrup
soft needle
What testing have you done? Have you tried different slicers? Is your start macro unaltered?
glossy stirrup
What testing have you done? Have you tried different slicers? Is your start macr...
Start macro is just from RatOS instructions
soft needle
What is the object you're printing?
glossy stirrup
What is the object you're printing?
Knobs for potentiometer
elfin cosmos
is this happening every time you start a print or ONLY on second print?
soft needle
Start macro is just from RatOS instructions
What about my other two questions?
glossy stirrup
is this happening every time you start a print or ONLY on second print?
Only this print in particular
glossy stirrup
What about my other two questions?
I tried moving object around, but not solving the problem. I am using the RatOS start macro