Recently started having this issue where my printer creates this pattern around circles. I checked the STL , made it in thinkercad , steps are the highest. Using prusaslicer 2.6 , in viewer the gcode looks like a circle.
Vcore 500 .
#circle not round
true sail
silver adder
Hi!
Having the same problem. One of the things I noticed right off the bat, .stl are bad. Try to export in .step. I made a cylinder in orca, pei Ted it out, less vibrations and the lines are not so evident.
The surface is not that good still, but I will try to put the printer on something sturdy, check the back motors for idlers and motor pulleys to be on same level, tighten the belts with a resonance app at least, to make them closer.
It is what I found today while researching for other printers.
Also jerk controls should be off in slicer. Maybe also turn accel to 0 just in case and let klippr handle it
limpid maple
ive got the same issue. other prints look fine, but anything round looks like this
silver adder
I have a post with everything I did. Basically:
Sturdy surface, where vibrations from the printer do not travel further, thus increasing end vibrations.
Check idlers and motor pulleys for being flush. It seems one pulley was too high.
Rerun accelero.eter when on sturdy surface.
Good to check lubing, whether the head does not move.
Belts belts and belts. Still a hot topic for me, as it seems I overtightened them. Maybe not, who knows. I know that my adxl is calibrated, that means I should.not have ringing in other prints, but I have. Or those are VFA's and then it's a whole other question, mainly in belt tension being maybe too high and motors
silver adder
Oh, and stl files are bad. Use .step if you design yourself. It will give a better model for the slicer to slice
limpid maple
I have a post with everything I did. Basically:
Sturdy surface, where vibrations...
what kind of lube do u use ?
silver adder
what kind of lube do u use ?
I used oil for the rails which is meant for sewing machines. It maches the consistency
Machine mineral oil Proline from Poland. Just a random one from local home depot
sinful hull
i got a similar issue. could you check my post? weird thing is... i got 2 identidal minions, only one has the problem
limpid maple
for me it was belt tension
sinful hull
to low? to high?
by tension was rather low, tuned it by ear to be the same as my good printer
sinful hull
is it 100% gone now?
limpid maple
for the test cylinder that I printed yes
sinful hull
thanks