timid tinsel
I have the 500x500 V-Core 3.1 (Enclosed), Bondtech LGX Lite, Rapido 2 UHF, 0.6mm Nozzle. We have been running MatterHackers Build PLA at 205/68. No adjustments to the speed on the SuperSlicer profile. Prints have a lot of stringing, spiderweb-like. We tried 1 mm/40 mm/s stock retraction settings, we are now at 10mm/40 mm/s. Any recommendations?
lost tangle
You really shouldn't need to retract that far, it wont change anything. Go back to 1mm, and try faster. I use 80mm/s, but I havent really calibrated it completely, just good enough. Also, funnily enough, faster accelerations and travel seem to reduce stringing for me, so maybe turn up your travel accels
I have bascially the same hardware configuration but rapido 1
radiant vapor
I’ve also experienced this. In my case it was because it hadn’t properly hot tightened my new nozzle. Not sure if this applies to your case, but wanted to mention it just in case.
timid tinsel
You really shouldn't need to retract that far, it wont change anything. Go back ...
Here are the settings on the profile
lost tangle
hmm, I use prusaslicer but heres what I have
my max volumetric is controlled by the filament even tho it says 30
I get very thin hairs when printing not-very-dry filament sometimes but its not like that
also I reccomend checking avoid crossing perimeters personally
it doesnt add that much print time and its very nice for some parts