Hello, so I finally have my 500mm v-core 3.1 setup and i am havig an issue with the bed mesh. The bl-touch probe will not be able to deploy at some points during the bed mesh because it is too close to the bed. How can I fix this? I tried the horizontal_z_move but it never did anything. I have attched my printer config below and hope you can help!
#BL-Touch Failed To Deploy
tidal sonnet
tidal sonnet
Figured it out! I had to add horizontal_z_move under [bed_mesh] istead of [bed_mesh ratos]
steep grove
Figured it out! I had to add horizontal_z_move under [bed_mesh] istead of [bed_m...
can you elaborate on this a little more? i have start started to have the same issue