EBB42 - Klipper doesn't use the extruder port

[shadow lantern]

I have been battling with this problem for 2 weeks, and the result is the same.
Klipper still goes through my Octopus V1.1 while I would like it to go through my EBB 42 V1.2...
I attach with the printer.cfg and the logs report.
Please help me !
#EBB42 #Octopus

[zenith leaf]

comment all I circled and try again

if you have a toolboard you need to "disable" standard config by commenting # everything you "move" to toolboard

[shadow lantern]

I have this but i must leave [probe] for z_offset

[zenith leaf]

that is a problem with the stepper driver/motor

check the power and wiring to board/ebb/steppers