#Supports and gaps around holes

15 messages · Page 1 of 1 (latest)

viscid dune
#

Are there any tricks in slicers which can help eliminating those gaps around hole on supported area?

20230727_073916.jpg
plucky urchin
#

have you tried increasing infill/perimiter overlap?

#

Although looking at your image closer up it looks like your flow rate is too low

viscid dune
#

Are there any specific flow rate config for those areas? The rest of the part are perfect in terms of flow

#

To make sure we are on same page - the part is upside down on photo, the problematic area is just on top of support

plucky urchin
#

oh so thats bridging?

#

what support type are you using?

#

organic would be ideal for these, I think

viscid dune
#

Default from Orca

dusty arch
#

This looks like the nozzle went all the way to the inside-wall of the hole, but there was nothing underneath it, so the filament didn't stick there. Maybe try decreasing the support pattern spacing? Do you have a screenshot of the slicer what the layer below (i.e. the support layer) looks like?

pseudo verge
#

This part should be printer facing down. Follow this picture for the orientation of the parts

printed-parts_layout_3.png
viscid dune
#

@pseudo verge This part printed differently for a reason: https://www.thingiverse.com/thing:5513555

Gold Series Rat Rig V-Core 3.1, XY joiners with clamping mod by MFBS

Improved Rat Rig V-Core 3.1 XY joiners.
Note this version of the mod is for the 3.1 upgrade of the V-Core 3 only.
The standard joiners use the bolts that act as the axles for the bearings stacks to clamp the XY joiners to the alumimium plate.
This mod also uses the cap screws that hold the aluminium extrusion into the the printed XY joiners to...

viscid dune
dusty arch
#

As I suspected. You need to make the dark green lines closer together. And maybe also the light green support structures below also, depending on how much sagging you get etc.

viscid dune