Beacon leadscrew safe_home_x

[burnt drift]

Hi, I'm trying to figure out how to set my safe_home_x position to a couple mm off center so my beacon probe doesn't hit my z leadscrew. I'm using the beacon recommended code but that doesn't seem to change where the default bounce back position is.
[safe_z_home]
home_xy_position: 107.5, 90 # update for your machine
z_hop: 3

I'm going to chop a couple mm off the top of my screw next week but until then is there something obvious I'm missing?

[warped cove]

Upload your printer.cfg

[burnt drift]

I will as soon as I get back home

[quaint lodge]

That is not a safe way to do it, you should limit your max y instead. You can do that by extending the Y endstop and changing position_max and position_endstop under [stepper_y].

[burnt drift]

I have done that but even with the maximum adjustment of the y end stop the beacon still hits the leadscrew. The default behavior has the x axis home then go to center of the bed. When the y axis then homes it hits the screw. Is there a way to change that bounce back behavior?

[quaint lodge]

There's an extended endstop on printables

[quaint lodge]

Please only do this temporarily, because you will damage your beacon eventually if you don't fix it properly. https://os.ratrig.com/docs/configuration/macros#homing

Also delete [safe_z_home]. It's not a thing in RatOS v2.

Alternatively you can use sensorless homing on Y, then you only need to change position_max since it homes at the front

[burnt drift]

Thanks, that should fix it until I can trim down that leadscrew. I haven't hit the beacon yet and hopefully that'll never happen. Unfortunately I'm running 5160s and I hear sensorless is not great if it works at all on them.