It was starting to do the bed leveling sequence. Then it stopped and gave this error. Probe triggered prior to movement. Confused on what's wrong since it was printing fine before.
#Probe triggered prior to movement
tawny spear
#v-minion
dire latch
Your probe is already registering the bed. Probably a wiring issue, verify that it is still working correctly
tawny spear
Endstop z still triggered after retract
I checked all the wires everything looks good. I'm still getting an error message
Do you think it could be because of the probe broke?
dire latch
I checked all the wires everything looks good. I'm still getting an error messag...
how did you check the wiring? Did use the query endstops with and without metal near the probe to verify it is working?
tawny spear
I did. And it still wasnt working. I tried a lot of different ways and it still didn't work. I am just going to replace it with a better sensor.
I ordered the same one prusa uses. I figured it might be the wiring but for the cost and my time rip it out and replace it with something better.
High Quality P.I.N.D.A V2 PINDA Sensor Auto Bed Leveling Sensor Probe 4PIN Compatible with Prusa i3 MK3 MK2.5 MK3S MK2.5S 3D Printer
dire latch
Pinda 2 is inferior to the superpinda. The superpinda that ratrig sells is exactly the same as the current sensor prusa sells
tawny spear
Oh, so superpinda? Does it matter much? my goal with getting it is to swap it and see. For a trouble shooting.
dire latch
Oh, so superpinda? Does it matter much? my goal with getting it is to swap it an...
Yes, unless you like having a probe affected by temperature