Any idea or guidance on where the skew may be. I built the VC3.1 with engineering squares and clamps so not sure what i did wrong.
#What frame skew causes this mesh
finite pasture
safe burrow
floral spear
first test...raise both front Y rail corners 0.5mm and run a mesh.
you can take a 90° corner brace mounted under the edge of the rail and a spare screw and nut as a jack to move the rail ever so slightly and precisely. (used like a car jack) Raising the fron should drop that back right corner to start.
floral schooner
Any idea or guidance on where the skew may be. I built the VC3.1 with engineerin...
Frame has clockwise twist in it from front to back... Twist the front of the frame clockwise to dial that out... Mesh also suggests some upward gantry bow, but the twist is your bigger issue...
Make sure to run a z tilt after adjusting for twist
finite pasture
Updated mesh’s think I’ve removed the twist as it looks to be bowed now
Just under 0.3 between lowest and highest point
floral schooner
0.3 range on a 500 bed is excellent - probably not worth chasing it anymore at this point - unless you need greater precision than that on a 500mm part