I am setting up my V-Minion right now and homing x and y works perfectly fine but Z does not move at all. Not sure what the problem is.
I also added my printer.cfg
Hope you guys are able to help me ty in advance.
#V-Minion Z-Axis won´t move when trying to home.
uneven shuttle
stray schooner
I am setting up my V-Minion right now and homing x and y works perfectly fine bu...
What probe?
Your config seems to indicate an inductive probe. Does the light turn on/off when you hold metal to it?
uneven shuttle
I got the super pinda from the rat rig shop I will try the metal
the light turns off when i hold metal to it
changed the printer.cfg to superpinda.cfg instead of probe.cfg but still no lockl
stray schooner
the light turns off when i hold metal to it
so far so good
And you checked by holding metal to it and running QUERY_ENDSTOPS or refreshing the status in the Machine tab? @uneven shuttle
It's not just because your probe is too high relative to the nozzle?
I completely missed this for some reason: fine but Z does not move at all.
That's probably what we should be looking at, and not your probe 
sorry
Does it move when you run SET_CENTER_KINEMATIC_POSITION and press the up / down arrows in Mainsail?
If no, check that your Z stepper cable is properly connected and properly crimped in both ends (verify with the wiring diagram).
uneven shuttle
okay i have no clue what just happend i switched to stepperdriver slot to motor 3 and turned the printer on and then the toolhead started to smoke. I cut power immidiatly
stray schooner
okay i have no clue what just happend i switched to stepperdriver slot to motor ...
The toolhead started to smoke? From what exactly?
I mean what component
uneven shuttle
not sure
stray schooner
I think it's safe to say you have some wiring issues 😄 post some pictures, so we can help you sort it out and replace the part that let out the magic smoke 😄
uneven shuttle
alright i will take some pictures
i am using a sanyo 4028 for part cooling and a noctua for hotend also orbiter filament sensor
dawn gate
what is that single yellow wire in the endstop for?
uneven shuttle
It’s from the orbiter filament sensor
uneven shuttle
Okay something precious must have fried my board that’s also probably the cause for the z Motor not working
*previous
It did turn on afterwards and everything so maybe only the slot is dead
stray schooner
this isn't inserted correctly, so that'll fry it.
It does look like that happened to z0 slot too
Hard to determine the damage from here. Could just be the step stick.
uneven shuttle
okay so what do i do from here?
stray schooner
okay so what do i do from here?
New driver / new board. Maybe both.
deep cargo
yep... board looks like it simply saw the extension of a stepstick burning up...board looks like it's just the receptor of the stepstick chip explosion and odds are it's ok BUT PAYOR...board might just fry a newly inserted new stepstick