softfever slicer artifacts | Rat Rig Community [Unofficial] | Page 1

placid hill Feb 11, 2023, 6:36 PM

#

overextrusion

lilac wasp Feb 11, 2023, 6:39 PM

#

When i use the cura i dont have this and i have put the same em maybe i can lower the extrusion for the bottom

placid hill Feb 11, 2023, 6:46 PM

#

then you have in cura the correct EM and in softfeaver a wrong one

#

you need to tune your extrusion multiplier

lilac wasp Feb 11, 2023, 6:48 PM

#

Its the same

placid hill Feb 11, 2023, 6:49 PM

#

show it

lilac wasp Feb 11, 2023, 6:53 PM

#

Left softfever right cura

placid hill Feb 11, 2023, 6:53 PM

#

thats the highest flow ratio i have seen so far 😆

#

no idea why it behaves like this

#

i am sorry, can thelp you more with it

lilac wasp Feb 11, 2023, 6:55 PM

#

I did the calibration flow test with the cube with the wall 0.8 i printed a cube and the size is correct maybe 0.1 off

#

Normally the em is below the 1 but maybe its the asa filament

lilac wasp Feb 11, 2023, 11:32 PM

#

Its not 1.5 its 1.056…

#softfever slicer artifacts