Rear corner dip

[eager field]

I've been wrestling with this for hours now, after having installed the Enclosure kit earlier today - each adjustment I make seems to throw something out of whack. I'm sure I can improve on this since the tolerance before installing the enclosure was about .19mm. I have been unscrewing the left and right extrusions and adjusting them up and down to try and bring it into square as detailed in the FAQ video, and measuring my adjustments with a caliper just to make sure I'm not going mad - any ideas appreciated! Thank you,

[near narwhal]

try to correct the back extrusion

not the side extrusions

the one one top of the z extrusion

after that, correct the side extrusions

[eager field]

thank you! 🙌 I'll see what I can find - do you mean the one at the top of the electronics panel? I think there are now 3 extrusions at the back of this one!

[near narwhal]

you have to loosen both side corners, yes

its the extrusion directly on top of the rear z extrusion

looks like its not straight

ignore the front corners for the moemnt, try to fix the rear one first

[eager field]

OK good shout thank you

this is the best I've gotten but it's still dipping in that corner, I'll take a look at the rear

although, in which direction would I adjust it?

[near narwhal]

right back side down

[eager field]

sorry if this is obvious but I don't see any way of actually adjusting this downwards?

[near narwhal]

other side upwards

put a thin business card between the extrusions on the other side

the extrusions are not perfectly cutted, some are a bit longer or shorter

[eager field]

ah ok that makes sense

are we putting a spacer in the red gap or the blue gap?

[near narwhal]

red

[eager field]

ok thanks I'll try that!