I am getting gaps in my perimeters. Tried changing line width in my Extrusion Width settings in Super slicer, but the spacing is also linked to it, so I can't seem to reduce the spacing to increase the overlap.
#Gaps in my perimeters.
prisma fable
signal pier
Have you calibrated Pressure Advance? And if - with which method?
After that an Extrusion Modifier Test (as integrated in SS) would be the next step to narrow this down if not done yet
digital goblet
Have a short look to "extrusion multiplier" in SuperSlicer. After installing the Vcore presetting from github, mine extrusion mulitlpier for PLA was set to 0.89 - which is too low. I'm using only Extrudr PLA NX2 Filament which needs 0.97 to work best.
prisma fable
Have you calibrated Pressure Advance? And if - with which method?
PA was done using the new pattern method from Andrew Ellis.
EM was set using the same guide., by printing the 30x30x5 chips and setting the EM for each.
Surface now looks good, but I still get gaps. Increasing the EM does solve it, but then the surface goes all haywire.
signal pier
Is the surface being overextruded then also on regular prints, or only on the test prints?
west orchid
I am getting gaps in my perimeters. Tried changing line width in my Extrusion Wi...
Why haven't you hired a 3d printer person to tune this for you? Probably would be cheaper than all the time and filament you have spent to get these unsatisfactory results