Hello all,
I've been printing now with my RR 500 for a couple of months now just fine. But a strange z probe issue has shown up. I kicked off a print but it stopped after homing all because after it did the z, the super z probe was still triggered. I read that this can happen when there is a break in the cable or connection to prevent damage. I don't use zip ties on any cables coming out of print head. I've checked connections on board..nothing has mad a difference. I had a spare super in the bag brand new, not opened, didn't attach to printer, just plugged it into the board. I ended up with the same result as the original. Am I now looking at a problem with the board? The board is a 466
Thanks
Jim
#z probe issues
delicate tusk
remote gull
have you confirmed that the wires are not broken at all? You can use a multimeter to confirm the wires have continuity
spice cipher
Hello all,
I've been printing now with my RR 500 for a couple of months now jus...
you can always connect it on other pins if you declare them properly
delicate tusk
have you confirmed that the wires are not broken at all? You can use a multimet...
Yea, when I hooked up the brand new backup z probe I didn't attach it i just hooked it up and got the same exact results.