I get this message when I start a print. (RatOS 2). Bed Mesh is done and named "ratrig", it's not applied.
For sure I have forgotten to set up something, but I don't find it.
Thanks for your help! 🙂
#Unknown command MESH_CONFIG
cerulean thorn
marble sparrow
thats a PAM command
its still in your slicer configured but you havent installed it again on ratos 2.0
cerulean thorn
I double checked, haven't installed this yet (waiting for the final Pi to arrive). Searching through the config.txt for "pam" doesn't give any results.
I'll take a few minutes to go through my printer.cfg line by line, but I am quite sure
marble sparrow
thats the issue, its still configured in the start_gcode in your slicer, but not available on your printer
cerulean thorn
thats the issue, its still configured in the start_gcode in your slicer, but not...
thanks. of course. for sure you just heard my hand facepalming hard.
marble sparrow
thanks. of course. for sure you just heard my hand facepalming hard.
i did
the windows almost broke
late lichen
https://github.com/HelgeKeck/pam
ref post https://discordapp.com/channels/582187371529764864/1050109013175578696/1050109092754100254
HK...does this conflict with.... or co-exist (run in parallel ) with the Adaptive Purging ?
https://discordapp.com/channels/582187371529764864/1050109013175578696/1050109330873139280
marble sparrow
ref post https://discordapp.com/channels/582187371529764864/1050109013175578696/...
adaptive purging?
late lichen
yes. I've noticed this purge works better when it's closer to the PAM'ed style mesh area (their version of localized meshing) The default purge line up the y-axis (at least on my bed) seems thinner than the brim printed around my item being printed. Plus the wipe always leaves a string when it zips over to the print area . This is kind of a blob and line and wipe all in one but right next to the item you are printing.
late lichen
no eval? oh well...guess I need to uninstall PAM and install that asset and compare. tnx