fix-my-printer
Stepper driver warning: OTPW flag set
other
Hybrid confusion
motion
Solved
RatOS Keeps Corrupting During Commissioning
setup
Issue with layershift
motion
2 printers same problem
other
Move Out of Range Error
motion
other
Belt aligned help
motion
Solved
setup
Beacon not recognized after IDEX upgrade
motion
Solved
setup
Issue with the X stop and possibly the Y
setup
Heater extruder not heating
Solved
setup
vcore 3.1 prints fine with prints that are up to 3 hours But with longer prints 5+ it layershifts
motion
other
setup
how to change probe offset on v minion
Solved
setup
unable to read tmc uart 'stepper_z' register ifcnt
setup
SOLVED VAOC Suggests misalignment, But tension and skew seem fine. What else could be wrong?
setup
Printing Speeds past 150.
motion
Stepper missing steps?
motion
Solved
VC3.1 - SuperPinda - !! Retries aborting: Probed points range is increasing. -Z-Tilt Problem
motion
other
Printing issues on new 500 IDEX
other
setup
VC4 Part cooling fan will only run at 100%
other
Crash after running belt tension test
Solved
setup
Access to configurator RatOS
setup
Part Cooling fan doesn't work
setup
Vcore 3.1 500, stops extruding mid print
other
setup
IDEX 500 Orbiter V2 Smart Sensor issues.
other
setup
Fix my racking
motion
No VAOC Camera Image
Solved
setup
Orbitor filament sensor
other
Endstop dual_carriage still triggered after retract
motion
Solved
Hotend change, what I need to change in klipper and slicer? (Clogging Problem)
Solved
setup
Z Rear not moving
motion
Solved
setup
VCore 4 500 - "Died mid-print, got an ADC out of range now. Thermistor tests 1.074 kOhm
other
YeagerBomb VAOC issues
motion
Solved
Adding an extra NIDEC Fan
Solved
other
Homing sequence kill homing switch
motion
Negative temp readings from Octopus V1.1 F446
Solved
setup
Nozzle Oozing at the threads
Solved
other
Configurating Machine
setup
Pei sheet chipping and peeling vcore 4 500
other
Extruder temperature not right
other
setup
Y linear rails offset or profile twisted
setup
Hotend temp and power osscilating even after pid tune
other
Kind soul able to examine my crowsnest.conf to help get my 2nd Camera working (2nd non-VAOC Camera)
other
Hotend temp reads 159 degrees at all time, phaetus rapido uhf
Solved
setup
Bed not heating - heater_bed not heating
other
Clicking noise when moving gantry
motion
hi, I have sometimes this problem:TMC 'stepper_z
motion
Rapido 1 Reading Lower Than Expected Temperature
setup
Fan stopping when klipper shows 70%
other
VAOC Chicago Bolt Doesn't Fit
Solved
setup
Klipper error after update
setup