fix-my-printer
Beacon calibration failing during comissioning
Solved
setup
Layer shifting during Skew Calibration Print - VC4 400mm IDEX
setup
VCore 4 unknown chip pin 'probe'
Solved
other
setup
Cat pissed on my printer. Need new parts. What do you recommend?
other
V-core 4 500 hybrid crashes gantry
motion
Solved
setup
Replacing MGN12C rails with MGN12H
setup
MCU unable to connect
other
Beacon probe Z-offset is consistently too far from build plate
other
setup
extrusion differences between near identical printers
Solved
other
Unstable Z (@calibration)
motion
setup
Unloading during printing
other
Filament detector doesn't seem to act properly
Solved
setup
odd behavior involving tool head fans
setup
_BEACON_APPLY_RUNTIME_MULTIPLIER
motion
other
Am I screwed?
other
Can't figure out why this noise exists...
motion
TMC 'extruder' reports error: GSTAT: 00000001 reset=1(Reset)
motion
Cannot Connect to Moonraker (randomly, frequently, during prints or just sitting there)
other
Toolhead configuration cannot be deserialized
Solved
other
setup
IDEX T1 not correctly bounded on X
motion
Solved
setup
Move exceeds maximum extrusion
setup
Rat Rig 500 Hybrid Y-Axis jumping and loud noise
motion
setup
Fan speed problems during toolchange
other
Wrong hotbed temperatur.
Solved
setup
Unexpected motion in X when moving Y
motion
Solved
Advice sought; Trying to tune TMC2209
Solved
other
WiFi w/external dongle - Pi4 - Enable dongle, disable internal WiFi if needed
setup
🛑 V-Core Z Homing Crash | “Shutdown due to X and Y must be homed before homing Z” Error on RatOS /
motion
Unable to read tmc uart 'stepper_y' register IFCNT
Solved
setup
Dumb question? Or I'm totally missing something. Commissioning Hybrid XY
setup
Ratos 2.x
other
IDEX layer shift
motion
IDEX Upgrade VCore 300
Solved
setup
RatOs operating system
setup
T1 Out of Range On Completion
motion
RPI not powering on
setup
Is this belt tension or something else?
Solved
other
Filament sensor always switches to detected after prime blob. I have tried everything and am stuck.
setup
Bad stepper motor?
motion
VAOC IDEX Calibration toolhead collision.
motion
setup
nternal error during connect: module 'extras.resonance_tester' has no attribute 'SweepingVibrationsT
setup
Burned or Bricked raspberry 4b - no 3.3v
other
Fan Confusion
setup
moonraker not connecting
other
Replacing my 24V heatcore but mistakenly ordered a 12v one
other
Cooling 4028 fan 12v won't run.
other
VC4 full kit: unable to read tmc uart 'stepper_z' register ifcnt
motion
setup
Chamber Temperature Display?
setup
Z-Offset / Beacon Compensation / RatOS V4 500 IDEX
other
setup
Flashing Octopus Board V1.1 & RatOS
setup