fix-my-print
Under extrusion on retractions
Solved
Extrusion
Issue with dimensional accuracy on the z axis
Other
Temp tower question
Extrusion
Sensor Equivalent
Solved
Other
Knocking hotend off track
Errors
Extrusion
prints too large
Solved
Other
First layer problem I cannot identify
Extrusion
Under Extrusion on corners
Other
Extrusion
Burn-through in ASA? What causes this failure?
Extrusion
Flow Issues?
Extrusion
Outside perimeter has reduces flow? seams between flow change look like crap
Extrusion
prime line keeps digging
Other
PETG build-up on my nozzle
Other
Errors
Extrusion
Help
Extrusion
Are there standard test print STL's beyond the ratrig commissioning first layer test print?
Solved
Other
is this a cooling issue?
Solved
Other
Extrusion
Ellis' Pressure Advance / Linear Advance Calibration Tool - not working on RatOS v2.1
Other
Variations in Layer Lines Around Geometry Changes
Solved
Other
Extrusion
Gaps in layers
Extrusion
Random line mystery
Other
Extrusion
TPU Infill Foam style Prints rapidly get worse in latter half of a print
Extrusion
Minion in Heated Chamber, Asa Problems with Edges
Errors
Extrusion
Uneven Extrusion on Infill
Extrusion
no good walls
Extrusion
extrusion issues
Extrusion
Consistent gaps between walls with proper EM and PA on VC4-400 hybrid.
Extrusion
terrible embossed lettering
Other
Zig-zag rippling on print
Solved
Other
Ripple in Pressure Advance Tower
Other
Extrusion
how to fix over extrusion.
Extrusion
And here we go again... first layer problem even with beacon3D
Extrusion
Ratcube Ringing on Vcore4 hybrid
Errors
anyone get any ideas
Other
weird artifacts on gayer-anderson cat
Solved
Other
Extrusion
vcore 3.1 PACF woes
Extrusion
First layer issues after Ratrig Toolhead upgrade
Errors
Extrusion
Filament breaks during bridging
Extrusion
V-Minion - Consistent perimeter print errors (Single wider layer + void)
Extrusion
1'st layer issue
Extrusion
MCU 'toolboard_t0' shutdown: ADC out of range
Errors
Strange Texture
Solved
Extrusion
PA-15CF - Printer has been calibrated, yet I keep getting these imperfections.
Extrusion
Vcore 4 Bad first layer
Other
Extrusion
First layer squeeze
Other
Can't dial in retraction
Extrusion
worbling on layer 2 (ASA)
Other
Extrusion
My 3d printer stopped when my print was about to start and it didn’t cancel my print but the hotend
Other
Errors
What does this look like?
Extrusion
Pillowing on very top surface
Extrusion
Underwhelming first layer after calibration
Extrusion