fix-my-print
Is this a z-offset issue?
Other
What types of surface artifacts are these?
Other
What setting is causing these fat perimeter overhangs?
Other
pressure advance issue ?
Extrusion
taking off the pei sheet
Other
Minor problems with ABS
Other
Gaps in perimeters
Extrusion
Holes Near Seam, Vertical Stripes
Extrusion
RR 3.1 500, First print problems
Other
closing the gaps
Other
Is there such a thing as too high of fan speed for bridging?
Extrusion
Z Wobble or bed PID?
Extrusion
Really bad Quality
Other
Some PETG prints to work on improving
Other
Extrusion
~9.54mm artifact bottom layer
Other
What could this be?(V Minion)
Extrusion
Guessing this is 4028 territory...?
Other
Extrusion
Walls having gapps
Extrusion
Two tone print breaking at new color start
Other
First layer issues on travel
Other
Extrusion
Skew on lower layers plus same height layer offset
Errors
Bridging issue
Other
Extrusion
Weird Under Extrusion?
Extrusion
Bed adhesion and warping issues
Other
Layer shifts and ugly surfaces
Errors
Layer shifts on longer prints
Other
Why is my infill looking so shit?
Errors
Extrusion
Blobbing issue after a few layers for a few layers
Other
Extrusion
warping with petg
Other
Extruder stops several layers in
Extrusion
Inconsistent squish across bed
Other
Errors
Brim is not consistent
Extrusion
Messed up infill.
Extrusion
V-minion Z wobble
Other
Printer goes to insane speeds and then starts skipping
Other
Errors
Visible lines around holes
Extrusion
Printer really loud
Other
weird wavy pattern
Other
Cube quality. Extruder issue?
Extrusion
Calibration cube quality
Other
Errors
Extrusion
Lines on the top
Other
Unstable extrusion when a new perimeter starts after unretraction
Extrusion
Terrible under-extrusion with TPU
Extrusion
Print warping
Other
Problems with large first Layers
Other
Extrusion
Inconsistent layers
Extrusion
Printing with ASA on V-Minion
Other
Heater extruder not heating as expected rate..
Extrusion
Possible Z Wobble? Inconsistent Layers
Other
Extrusion
Heater extruder not heating at expected rate
Errors